Typically by default this is what you would see for a regular wired nic card after opening properties. Type in int teredo and press Enter Type set state disabled and hit Enter Open Device Manger and Uninstall Teredo Tunneling Pseudo-Interface Go back to the command prompt and type in netsh and hit Enter Type int ipv6 and press enter Enter in set teredo client and hit Enter Go back to the Device Manager and Scan for New Hardware. In the run dialog that opens, type hdwwiz.cpl and Click OK. To install it, go to device manager OR Hold the Windows Key and Press R. If nothing is listed then you need to download the right driver for your pc. In this section, I’ll show you how to install the Teredo Tunneling Adapter on Windows 7 the driver is built into Windows 7. After choosing protcol another list opens and you should see IPv6 in there. The list is made up of client/service/protocol.Īfter pressing the install button you can select which type to install client/service/protocol In your case you want a protocol. Right click the adapter and to go to properties. When prompted, provide your permission to uninstall the driver. Select Uninstall to uninstall the device. Open Device Manager, proceed to Network adapters and right-click the Microsoft Teredo Tunneling adapter. If you have both a regualr wired nic and a wifi nic then you need to select which one you're using. How do I fix Microsoft Teredo Tunneling adapter has a driver problem Resolve PC Issues with Driver Updater. So you go to start, run & type in ncpa.cpl hit enter. It usually is installed by default, but since you had issues you probably reinstalled your nic card and ipv6 wasn't installed. Is the ability to do ipv6 tunneling over ipv4.
0 Comments
Leave a Reply. |